1.Electric hydraulic pump can be used as a variety of hydraulic equipment hydraulic pump.
2. After the electric hydraulic pump and other hydraulic tools are equipped, it can carry out a great deal of work such as lifting, pressing, bending, bending, aligning, shearing, assembling and disassembling. Reduce labor intensity, improve work efficiency.
Electric hydraulic pump Usage:
Open the bleed nut when using, open the switch on the oil collecting block, plug in the power supply, and fasten the quick connector on the quick head equipped with hydraulic equipment. Press the power switch, until the motor rotates 1-2 minutes, the switch is closed at the supercharged state, the hydraulic oil output at this time will carry out various tasks, the output hydraulic oil with the increase of load self-pressurization of the work until 63MPA .
After the work, open the switch to unload until the hydraulic oil back to the end, remove the quick connector sleeve, spin a good deflated nut, unplug the power, the switch off.
Electric hydraulic pump maintenance precautions:
1. The pump uses 20 oil.
2. Oil storage capacity must be within the oil window range.
3. Each refueling and oil change, must be more than 80 mesh filter oil filter, replace the need to wash the fuel tank. Oil change period of six months.
4. Working oil temperature 10 degrees Celsius to 50 degrees Celsius.
5. Before starting the electric pump, open the bleed nut and open the switch to unload position.
6. The process of using the motor temperature is too high, should be discontinued. Self-cooling before use.
7. The pump has been adjusted before leaving the factory, not free high-profile, to be readjusted, you must use the pressure gauge.
8. High-pressure tubing factory, after 105MPA test. However, due to easy aging hose, so the user should always check, usually six months, frequent use for three months, check 87.5MPA pressure test, if damaged, raised, leakage can not be used.
9. Bearings are generally cleaned once every six months, the assembly need to add grease.
Transfer trolley, an motor driven factory transport vehicle. It has the advantage of simple structure, easy maintenance, large carrying capacity and less pollution. Widely used in machinery manufacturing and metallurgical plant, cooperate with cranes to transport heavy loads inside workshop. They can be divied in many different types as shown below:
· KPT type transfer trolley is powered by the cable laid on the ground directly. For its simple structure, the price is more competitive. While the distance is often limited in 100 meter.
· KPJ type transfer trolley is powered by the cable from the cable reel. With the cable reel, the moving distance is improved to 200 meter compared with the KPT type.
· KPX type transfer trolley is powered by the storage battery, more flexible and safe. While the capacity and the duty group are all affected by the storage battery. Especially, the price and the life span of the bettery is also an important issure.
· KPC type transfer trolley is powered by the slide wire along the rail, so the moving distance is unlimited. The slide wire is the key point and also the weakest link.
· KPD/PKDZ type transfer trolley is powered by the low voltage DC power from the rail. Powered by the rail, the system is more reliable compared with the KPC type; The sytem is also more complicated and expensive.
Title Transfer,Plate Transfer,Car Title Transfer,Transfer Car Ownership
XINXIANG DEGONG MACHINERY CO., LTD. , https://www.degongcrane.com