The numerical control unit is equipped with the “B00†series. First, the visibility of the display device is improved for the convenience of the operator. In the past, 10.4-inch monochrome LCD panels have been used, and now they are replaced by 12.1-inch large color panels.
At the same time, in order to improve production efficiency, the B00 series will increase the number of axes that can be simultaneously controlled from the last three to four. Therefore, it is possible to simultaneously control the X, Y, and Z axes on the spindle side of the turret and the indexing axis on the side of the table on which the workpiece is fixed, for a total of four axes. This makes it possible to cut a more complex shape like the 4-axis control MC (Note: Although the device can control up to 5 axes, it can control up to 4 axes at the same time. In addition, the table side is indexed. Up to 2 axes can be installed).
In terms of productivity improvement, the production cycle time is also shortened. While shortening the rise and fall times of the spindle, the non-cutting time is shortened by 7% by developing a time constant that can set the optimum rapid feed according to the weight of the workpiece placed on the console.
In addition to this, it also expands the space of the processing room. By moving the machine tool column that was in the processing chamber in the depth direction of the machine tool body and changing the film-shaped Z-axis cover (film cover) into a plate-like cover, the space in the depth direction is enlarged by about 150 mm. Therefore, the processing chamber can be expanded up to 1500 × X axis direction 1020 × Z axis direction 480 mm in the X-axis direction, and is 43% larger than the past in terms of volume. Not only does the freedom of the fixture used increase, but more workpieces can be cut.
It also improved the coolant spray method called “Chip Showerâ€. A flexible nozzle that can flexibly adjust the direction of the nozzle is used to spray the coolant from a higher position inside the processing portion like a shower. Improve the discharge performance of the chip and improve the production efficiency.
YQ(Y)W series gas-fired/oil-fired thermal oil boilers have a three-pass round coil structure. A conical coil is used for the effective protection of the furnace wall at the boiler end. This product is equipped with an advanced combustion device and is fully automated in operation. After the burner ignites the fuel, flame fills the round coil tubes and transfers heat by radiation through the tube wall (first pass). The high temperature flue gas gathers at the back door and then turns to the convection tubes section (second pass), where heat transfer takes place by convection. The flue gas gradually cools down here and flows to the front door, where it is reversed and goes into the third pass. After that, it enters into the chimney through the economizer and is released into the atmosphere.
This type of heater is delivered as a whole, and is installed on site, it only needs to connect thermal gas(oil) piping and electricity to start operation. The heater has four heating areas: furnace radiation heating area, the first convection tube bundle heating area, the second convection tube bundle heating area and economizer (waste heat boiler).
YQ(Y)W Series Gas/oil fired Thermal Oil Heater
WUXI ZOZEN BOILERS CO.,LTD. , https://www.cnzozen.com